Nicole Esposito retweeted
Our recent study in JNER optimized whole-leg exoskeleton assistance at a range of walking speeds. jneuroengrehab.biomedcentral…
Are benefits from exo assistance speed dependent? Yes!
Does optimized exoskeleton assistance change with walking speed? Not as clearly as you would think. 1/7
Anyone know any good papers comparing actual knee joint center (projected intercept of tibia and femur) to approximate knee joint center (estimated @ femoral epicondyle) in the sagittal plane? I feel like it has to exist, I just can't find it...
When they told me I'd be managing a top-notch research lab, can't say this is what I pictured myself doing
Nothing quite like an hour and a half of table tennis while wearing EEG to make you realize how absolutely out of shape your upper body is... #IAmSoSore
When you realize your lab has been using the UF file directories all wrong and you're about to have to migrate terabytes of data to a completely different file system and completely rework a lot of lab operations and documentation: youtu.be/yBLdQ1a4-JI
How I'm coping with the fact that I'm going to have to reprint the entire Mando armor in PETG because evidently PLA is more heat sensitive than I had assumed, and that I got lucky when I did the helmet because today when I took more of the armor outside to sand it, it melted...
1
2
Nothing quite like starting a 8.5 hour print a couple hours before bed, knowing it'll be done before you wake up, only to wake up to it on hour 10 of printing and *still going*
... Did I never actually share on here that I'm printing the full Mandalorian armor? Not just the helmet? Because I am... Pics to follow
Finished printing the left vambrace today (temporarily took off the whistling birds and hot glued the hinges on just to check that it would work). Plan is to wire up some micro LEDs inside the whistling birds that light up when I flex my wrist.
1
Getting fit is about setting realistic goals, like being in good enough shape to walk up Center Drive without feeling like you're going into cardiac arrest...... Wait hold on, I may have misspelled "unattainable"...
1
Nicole Esposito retweeted
If you watch one video today, make it this one – A fresh look behind the @ILMStageCraft #virtualproduction technology as used on #TheMandalorian season 2. https://teapaw.org/t.co/SBYRDakrGc #vfx
New Artillery Sidewinder 3D printer is so quiet that the rare times is makes a little noise, it actually makes me jump because I forgot it was running.
Amazing what just one more layer of filler and sanding will do... You can actually see my reflection in it!!! And this is just 320 grit... I plan to go to at *least* 1000 grit on the actual helmet, probably higher...
Black spray paint + graphite powder = pretty decent chrome look for minimal cost... Still deciding if I'm going to want to clear coat it or not...
3











