HB3YJR (@Shortwave_Fan) header
HB3YJR (@Shortwave_Fan) profile picture

Shortwave Enthusiast since the last Century: SWL, CB, HAM Radio, QRP Lover. Kt. Zurich, Switzerland 🇨🇭

Joined November 2021
Photo by HB3YJR (@Shortwave_Fan)Photo by HB3YJR (@Shortwave_Fan)Photo by HB3YJR (@Shortwave_Fan)Photo by HB3YJR (@Shortwave_Fan)Photo by HB3YJR (@Shortwave_Fan)Photo by HB3YJR (@Shortwave_Fan)Photo by HB3YJR (@Shortwave_Fan)Photo by HB3YJR (@Shortwave_Fan)Photo by HB3YJR (@Shortwave_Fan)Photo by HB3YJR (@Shortwave_Fan)
チュートリアル:UHF 430 MHz コリニア垂直アンテナ(2 x 5/8 ラムダ) の製作 🎥Noormans Noor
1
17
1
103
4,477
What happens when a mature technology is pushed to its absolute physical limit? You get the Nuvistor—the "final stand" of the vacuum tube. After my post yesterday with the photo of the Nuvistor, here's the full story. Introduced by RCA in 1959, the Nuvistor was a masterpiece of miniaturization. It was built to prove that thermionic valves could be just as small, efficient, and reliable as the emerging (but then-flawed) germanium transistors. While traditional tubes were fragile glass "bottles," the Nuvistor was an all-metal and ceramic thimble, roughly the size of a fingertip. It didn't just look different; it reimagined tube physics from the ground up. What made the Nuvistor a technical marvel? 🔹 Low Noise & High Frequency: Its concentric, nested-cylinder design was exceptionally "quiet" and stable at VHF and UHF frequencies—areas where early transistors simply couldn't compete. 🔹 Ruggedised Construction: By brazing elements into a rigid ceramic frame, RCA made a tube that was virtually immune to vibration (microphonics). 🔹 Thermal & Radiation Resilience: It could operate at temperatures up to 200°C and was naturally resistant to radiation and EMPs, making it a staple for early aerospace and military hardware. Where did it leave its mark? 🔹 High-End Audio: Still used today in legendary microphones like the AKG C12VR for its unique "tube warmth." 🔹 Space & Defense: A primary candidate for early satellite technology due to its reliability in harsh environments. 🔹 Test Equipment: Found in the input stages of iconic Tektronix 500-series oscilloscopes. The Nuvistor eventually lost the war to the Silicon MOSFET, but it remains a poignant chapter in the history of electronics—a reminder that innovation doesn't always go quietly into the night; sometimes, it goes out as a masterpiece. Want to dive deeper into the physics of the Nuvistor and why it’s still prized by audiophiles and engineers today? 🔗 Read the full story here - The Nuvistor: RCA's Final Masterpiece: electronics-notes.com/articl… #ElectronicsEngineering #HistoryOfTech #RetroTech #VacuumTubes #AudioEngineering #RF #SpaceTech #EngineeringExcellence #ElectronicsNotes
6
18
3
107
5,794
👀
8
21
3
162
10,486
I have released my HF DX Index Windows App apps.microsoft.com/store/det…
3
10
39
1,446
My kind of lunch box..🤩
22
38
3
683
13,392
HB3YJR retweeted
Located in Monticello, Maine, WBCQ is an up-to-500,000 watt shortwave powerhouse that covers the world via 7.490 MHz, 9.330 MHz, 5.130 MHz, 3.265 MHz, and 6.160 MHz — depending on the time of day, to maximize signal propagation by bouncing off the ionosphere. Here is the WBCQs antenna.
6
40
4
267
6,313
Did you know? The SR-71 needed special OIL for the engine: then finding a leak in the hydraulic fluid required the special maintenance. The oil needed to be warmed up!  The following was recently written by SR-71 Pilot, Stormy Boudreaux. MIL-L-8700 this was uniquely different, other aviation oils had a max temp alloawance of 250 degrees C. But the J-58 engine would see temperatures 3 to 5 times that. However, the oil at normal outdoor temperature was like honey and the oil needed to be heated before engine start. It was similar with the hydraulic fluids of the day, new hydraulic oils needs to be created to withstand the very high temperatures the airframe was exposed to. This led to so very different maintenance actions. Hydraulic leaks often did not materialize until the very high temps associated with high mach flight. So when a hydraulic system was low on fluid after landing they knew there was a leak but it wouldn’t leak at normal ambient temperatures in the hangar even on the hottest of days. So the hydraulic fluid had to be run through special heaters and pumps to raise the temp to many hundreds of degrees – finally allowing discovery of the leak point – then after the system cooled and repaired then it had to be reheated to test that the repair had fixed the issue. I didn’t know this. The people who maintained the SR-71 and a lot of different work that they had to do. Their work was never done Linda Sheffield.
19
66
5
403
11,108
Check my qrz.com/db/HB9VQQ page for an up-to-date list of my shared SDRs
2
4
39
1,640
An introduction to Software Defined Radios. A thread for beginners on: 1. What a SDR is 2. What you can do with SDRs 3. How it plays a role in the security/hacking world 4. How it’s used in ham radio. 5. How to choose/buy one 6. Link to more reading material 0/21
24
268
18
2,134
162,134
HB3YJR retweeted
We have another contender for the title of "Oldest Ham Radio Club in America." Check out Frank's link; foxmikehotel.com/wp-content/…
Replying to @K3TripleR
They say that…but 1907 had the Bay Counties Wireless Telegraph Association in California. See: foxmikehotel.com/wp-content/…
2
15
889
This rare picture of Det 2 shows a maintenance area in the Skunk Works in Palmdale, California. You’ll notice (on the far right) in this photograph of SR 71, 955 The first test bird SR-71 was the 955. The last test bird was the 972. The skunk on the tail meant it was a Skunk Works test bird. The first test bird, SR-71, was 955, and the last was 972. The 955's last flight was on January 24, 1985. Because she had been modified so many times, she did not represent the SRs flown at Beale. Due to extensive rotation maintenance, the next SR-71 was made the new Skunk Works test plane. This is how the 972 received the “senior skunk” on her tail. This is the same SR-71 that made the flight from Los Angeles to Washington, D.C., in 64 minutes. You can see it in the place of honor at the Smithsonian Air and Space Udvar-Hazy Center in Sterling, Virginia.  Linda Sheffield
12
96
1
834
17,501
18
336
9
4,966
83,707
463
6,370
393
55,132
2,427,216
AU2V Sacrifice Rock DXpedition working pileup on 28260 kHz! Split mode, 5 UP. That means that they are listening on 28265 kHz and transmitting on 28260 kHz. You have to transmit on 28265 kHz. I could work them easily in first attempt itself. No local skip! youtu.be/Rcipz6JNwbI
3
5
410
Florence Violet McKenzie was Australia's first female electrical engineer. Her great enthusiasm was the new medium of radio, and in 1922 she was the first Australian woman to take out an amateur radio operator's license.
1
29
1
166
3,125
Took the KrakenSDR out for some fox hunting today and realized it’s time to turn my messy box of parts into a proper field RF kit for broader intelligence-gathering operations. To that end, I'll add additional SDRs, like the HackRF, to increase the spectrum coverage. The plan is to add waterproof pass-throughs for all the antennas and other ports to make everything more durable and field-ready. What other useful tools and software would you suggest for this build? #SDR #KrakenSDR #RFAnalysis #FoxHunting #hamradio #sigint
24
58
6
590
39,559
G4CMM 1970's #HamRadio
5
16
1
194
2,846
DJ4PT Quad Antennas He became Silent Key on February, 20th 2019. RIP
7
1
66
1,266