
Figuring myself out one build at a time @edenhousesf 🍃💫 💗 data science, whimsy electronics, 3D printing
San Francisco, CA
Joined February 2026
- Tweets202
- Following185
- Followers68
- Likes433
DD retweeted
初めてAgentを使ってロボットを動かしました!
Gemini 4 Hydrogenがカメラ映像からキューブの場所を推定して、IKで関節角度を計算して制御してくれています。
VLAは使っていないので、データ収集やModelのTrainingはせずに、Agentが自分で何回か試行錯誤して微調整していました。
Attendance by face. No cards. No list. Just look at the camera.
A small camera sits on top of a board, with a screen right under it. It says «Scanning face» and a bright white light turns on.
Known face → «Welcome, attendance marked» → a green light turns on.
Unknown face → «Unknown face» → a red light turns on instead.
A tiny camera, a screen, two lights and a handful of wires. That’s the whole system.
Would you trust this at your school or office?
DD retweeted
Teleoperating an OpenYAM using AR
It’s very satisfying to see the overlay match the physical motion.
Hand tracking on @specs feeds the IK solver from @dimensionalos which drives the physical arm.
DD retweeted
You should tag us when you build cool Raspberry Pi stuff. Sometimes we put cool makers in Raspberry Pi Official Magazine...
raspberrypi.com/news/mechatr…
DD retweeted
Our wheeled base just learned to fall and get back up.
Same kit as the arm and the biped, just rebuilt. One platform, five robots.
You saw it in sim. Here it is on the real robot.
Still think they're all different?
DD retweeted
Updated the Electronics 101 app with 20 new lessons!
You can now play around with logic gates, op-amps, 555 timers, and more.
electronics-101-six.vercel.a…
DD retweeted
This ESP32 Board Turns Quadruped #Robots Into Smart Robot Dogs
by @Alacritic_Super
#EmergingTech #Technology #Innovation
DD retweeted
wow some of you are actually so afraid of ever being uncomfortable you’re never gonna do anything interesting.
DD retweeted
it took six months and twelve servos to spin a globe without ever letting go
four robotic fingers take turns lifting and repositioning while the others keep the globe supported
watch the fingers and you'll see where the time went
OmarBuilds made it with 3D-printed parts and an Arduino-compatible controller
a desk sculpture built around a real robotics challenge: turning an object without ever letting go






















