pyroesp (@pyroesp) header
pyroesp (@pyroesp) profile picture

Bachelor in electronics, occasional programmer, I like retro gaming, art and photography (Lumix DMC-FZ62). I also like bunnies.

Joined September 2017
Made a shelf for my Japanese Dragon Ball manga.
1
35
I fixed these Tuya controlled Aubess Smart plugs by changing the 10V 470uF capacitor (top left) to a 16V 220uF. I would have liked to change it to at least a 25V 470uF, but I didn't have any on hand. The capacitance is a bit lower, but they work again.
2
1
74
Replying to @minagi_yu
Nice! I'm also making a VFD clock. github.com/pyroesp/One-More-…
1
1
120
The ID I have match the IDs found on nocash's documentation, but probably newer ID's were not added later on. I have tested them all, except the dualshock one which was added later on by someone else in the code.
1
1
17
Here's what you should expect the data to look like (assuming you got the same controller): youtube.com/watch?v=dBLZW0fI…
1
1
41
Chilling at a friend's house 🤙🏼
3
55
Replying to @RetroGamerArt
All of them! Pictures are old, recently got the white one.
1
10
373
Made my own IV-22 VFD tester. Each segment connected to a driver made out of a MOSFET and BJT combination. MOSFET switches the high voltage and the BJT controls the MOSFET from a microcontroller signal.
1
2
139
Replying to @VEsoterica
If you have the config password then there's a command to reset the write (and read) password.
2
28